Weird infill | 3D Printing | Page 1

tender atlas May 26, 2023, 6:19 PM

#

My printer seems to not do infill where needed but will then stop and keep extruding in certain areas.

pure mapleBOT May 26, 2023, 6:19 PM

#

tender atlas My printer seems to not do infill where needed but will then stop and keep extru...

#

AI Help

It sounds like you may have an issue with your slicing settings. Check your infill percentage and make sure it is set appropriately for your model. Also, check for any gaps or overlapping sections in your model that may be causing the printer to extrude too much in certain areas. You can also try adjusting the print speed and temperature to see if that helps. If none of these steps help, it may be a mechanical issue and you should check your printer's hardware.

tender atlas May 26, 2023, 6:20 PM

#

Printer is a monoprice maker select plus. It never used to do this. And my last print that didn't really require infill was fine.

pure mapleBOT May 26, 2023, 7:22 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

tender atlas May 26, 2023, 7:59 PM

#

Has anyone had anything like this before?

pure mapleBOT May 26, 2023, 9:02 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

tender atlas May 27, 2023, 8:57 AM

#

Still an issue

#Weird infill