Using a CR-Touch, when homing z, klipper moves to center but moves down infinitely | 3D Printing | Page 1

small warren May 23, 2023, 10:13 PM

#

I am using a BIGTREETECH SKR mini E3 v3.0 for my mainboard. Full config in attatchments

📎 printer.cfg

acoustic oarBOT May 23, 2023, 10:13 PM

#

small warren I am using a BIGTREETECH SKR mini E3 v3.0 for my mainboard. Full config in attat...

#

AI Help

As an AI, I don't have access to file attachments. However, I can offer you some general advice for working with the BIGTREETECH SKR Mini E3 v3.0. This is a popular mainboard among 3D printing enthusiasts and is known for its affordability, reliability, and compatibility with various 3D printer models.

Here are a few tips to get started:

Make sure you have the latest firmware installed on the board. You can download firmware files from the BIGTREETECH website or from the community forums.
Verify that all the connections on your printer are properly connected to the board. Make sure the wires are seated securely and in the correct locations.
Check your voltage settings. The SKR Mini E3 v3.0 supports a wide range of voltages, but you need to make sure the board is configured for your specific voltage setting. If you're not sure what to set it to, consult your printer manual or the manufacturer's website.
Test the stepper motor drivers. If you're experiencing issues with y...

small warren May 23, 2023, 10:15 PM

#

btw this is on an ender 3 v2

covert remnant May 23, 2023, 10:33 PM

#

small warren btw this is on an ender 3 v2

in your bltouch section change the sensor_pin to ^PC14 and take out the pin_up_touch_mode_reports_triggered

small warren May 23, 2023, 10:33 PM

#

OK

#

oops caps

#

lol

#

got my cursor on ESTOP

#

it fucking worked

#

tysm!!!

#

?solved

#Using a CR-Touch, when homing z, klipper moves to center but moves down infinitely