How do i edit my gcode so that it starts printing above a certain height | 3D Printing | Page 1

naive gate May 23, 2023, 1:22 PM

#

My print failed midway through, i decided it would be easier to just print the other half. The image shows what needs to be printed. How can i modify my gcode to print the top remaining part. Thank you

placid isleBOT May 23, 2023, 1:22 PM

#

naive gate My print failed midway through, i decided it would be easier to just print the o...

#

AI Help

I'm sorry, but I cannot see an image or the specifics of the print. Can you provide more information about the issue you are facing? What type of printer and filament are you using? What happened during the failed print?

raw seal May 23, 2023, 1:24 PM

#

if it works like cura, you can just drop the part in negative z below the buildplate and it will ignore it

naive gate May 23, 2023, 1:25 PM

#

that is not an option for my case because the orientation and size was not recorded.

raw seal May 23, 2023, 1:27 PM

#

so you just want to print the part above? why not just slice it like a normal part then?

naive gate May 23, 2023, 1:29 PM

#

?solved

#How do i edit my gcode so that it starts printing above a certain height