#print stops moving up

1 messages · Page 1 of 1 (latest)

viral plume
#

randomly my creality ender 3 will stop moving up this happens at different points this has been randomly happening at different points which then makes the bed leveling fall out . I also use the prusa slicer .

harsh quartzBOT
#
AI Help

There could be several reasons why the Creality Ender 3 stops moving up randomly. One possible reason could be a loose connection or damaged cable. I recommend checking the wiring and make sure everything is securely connected. Another possible reason could be an issue with the Z-axis limit switch. Check if the switch is working properly by manually triggering it with a piece of metal. Lastly, it could also be a problem with the firmware. You can try updating the firmware to see if that resolves the issue. If none of these solutions help, it may be worth contacting the manufacturer or seeking assistance from a professional technician.

WARNING: This response is AI generated and may contain errors.
harsh quartzBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

viral plume
#

.

harsh quartzBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

viral plume
#

.

reef tide
#

have you tried moving the z axis on its own?

#

i had this issue a few days ago make sure your lead screw is connected to the motor properly, that was my issue

harsh quartzBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

fleet kestrel
#

Is the rod in the coupler?

stable hull
#

Also worth checking the plugs/ pins are properely seated at motor and control board ends