#why are my prints going out of control?

1 messages · Page 1 of 1 (latest)

oak token
#

I have tried different filaments, changing the bed temp, nozzle temp, Recalibrating the levels, print speed. But nothing seems to work. I’m noticing the upper left print is always way more messed up than any other spot on the printer bed. #1080216363748036738

gleaming briarBOT
#
AI Help

It sounds like you may be experiencing issues with bed leveling or adhesion. I would suggest trying the following:

  1. Make sure your print bed is clean and free of any debris or residue. A dirty bed can affect adhesion.

  2. Check your bed leveling. Use a level tool or a piece of paper to adjust the bed at all four corners and the center to make sure your bed is evenly aligned.

  3. If the upper left print is still problematic, try moving your print to a different spot on the bed. It's possible that the bed may be warped or there may be an obstruction in that area.

  4. Try using a bed adhesive such as hairspray, glue stick, or a specialized product like BuildTak to help with adhesion.

Hopefully, one of these solutions will help resolve your issue.

WARNING: This response is AI generated and may contain errors.
oak token
#

The first layer is adhering perfectly it’s when it continues to print that’s the issue.

gleaming briarBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

earnest apex
#

you sure that the filament isn't snagging on something?