Sliding Prints | 3D Printing | Page 1

misty loom May 13, 2023, 3:57 PM

#

I use a ENDER 3 V2 NEO. I can get prints started but about have way they slide off the print bed and mess up. I am using rafts. The bed is level and I'm using suggested print settings. 60* print bed 200* nozzle. Using credulity CV PLA

tepid zenithBOT May 13, 2023, 3:57 PM

#

misty loom I use a ENDER 3 V2 NEO. I can get prints started but about have way they slide o...

#

AI Help

If your prints are detaching from the bed even with a raft, the first thing you can do is to ensure that the bed surface is clean. Please clean the bed with isopropyl alcohol, to remove any grease or oils that may be interfering with adhesion.

Also, you may want to try another adhesive such as glue stick, hairspray, or painters tape on the print bed to help the filament stick during the printing process.

Another possible solution is to adjust the bed temperature. Try increasing the bed temperature to 65 °C to see if it helps to improve the adhesion.

Lastly, you can try decreasing the printing speed and enabling the raft adhesion type in your slicer settings. This can help to ensure that the raft is properly bonded to the bed, which means that the printed part will adhere better.

tepid zenithBOT May 13, 2023, 5:02 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

misty loom May 13, 2023, 9:22 PM

#

.

quasi comet May 13, 2023, 10:15 PM

#

are you using the stock bed? those are awful I can barely get those to work lol

#Sliding Prints