#top layer non existent

1 messages · Page 1 of 1 (latest)

past ivy
#

Image attached- prints come out with wall lines exposed and no top skin. Looks ugly and need help understanding why it doesn't generate top payer

IMG_20230512_145736_197.jpg
woven lionBOT
#
AI Help

This issue could be caused by a number of different factors, but the most likely cause is that the printer settings in your slicing software are not set up correctly. Here are a few things you can try to troubleshoot the issue:

  1. Check your layer height: Make sure that your layer height is set low enough to create a smooth, solid top layer. If your layer height is too high, it may not fill in the gaps between your wall lines.

  2. Increase your top layers: Increasing the number of top layers in your print can help fill in any gaps and create a smoother finished surface.

  3. Adjust your infill settings: The amount and type of infill you use can also affect the quality of your top layers. Try increasing the infill density or changing the infill pattern to see if that helps.

  4. Check your cooling: If your printer is overheating, it can cause the plastic to warp or droop, leaving gaps in your top layer. Make sure your cooling fan is turned on and functioning properly.

  5. Update your ...

WARNING: This response is AI generated and may contain errors.
woven lionBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

restive sage
#

Also post your slicer settings - could be minimum shell thickness

past ivy
restive sage
#

Yep, I am also at work/have kids so I'll reply when I can if you ping me.

past ivy
restive sage
#

Ah, in which case need to check settings. If the thickness is less than your layer height or line width it cannot print it

#

Can you show the raw model before slicing?