compatibility issues?

[atomic forum]

I have a modded ender 3 V2:
Dual belted z axis with independent stepper motors Cr touch Revo Hemera xs dual 5015 blower fans
Full linear rails
BTT skr mini e3 v3.0 ( fried itself when connecting micro USB to computer due to a vent pin on the board side)

Goal: Run klipper with input shaping, pressure advance, dual z tramming, and a touch screen.

Hardware that I am looking at getting but unsure of compatibility:
BTT manta e3 ez
Ez2209 drivers
Tft 35 spi v2.1 display
BTT Cb1 v2.2 w/ heatsink

Hopefully some of you could give me insight or personal experience that will help me make my decision.

Planning on printing a separate enclosure for the electronics anyways so that will not be an issue.

[mint quartz]

AI Help

It sounds like you have already made a lot of modifications to your Ender 3 V2 and have some specific goals in mind.
Regarding the hardware you are considering, the BTT Manta E3 EZ and EZ2209 drivers should be compatible with your current setup, and the TFT 35 SPI V2.1 display should work as well. The BTT CB1 v2.2 with a heatsink should also be a good addition to your setup.

If you decide to use Klipper firmware, note that it may require some additional tuning for your specific printer setup, but it can provide some advanced features like input shaping, pressure advance, and dual z tramming as you mentioned.

One thing to keep in mind is that making too many modifications at once can make it difficult to narrow down issues if something goes wrong. I suggest carefully testing and tuning each new addition before moving on to the next one.

Good luck with your upgrades and happy printing!

WARNING: This response is AI generated and may contain errors.