#my files don't work

1 messages · Page 1 of 1 (latest)

crude python
#

I have a flight bear gost 5 printer, the issue is that for some reason it doesn't stamps properly. I've converted the files from object to STL and from stl to gcode, since that's what the printer recognises, but it still only pump out plastic without even arranging it into a vague shape of what I wanted. The files in questions are for my warhammer minis, I'm worried that my printer might not be able to do them.

serene steppeBOT
#
AI Help

It sounds like there may be a few issues here that could be causing the problem. Here are a few troubleshooting steps to try:

  1. Check your slicer settings: Make sure that your slicer software is set up correctly for your printer and the specific models you're trying to print. Check the print speed, layer height, infill density, and support settings to see if they need to be adjusted.

  2. Check your filament: Make sure that the filament you're using is the right size and type for your printer. If it's not extruding properly, it could be a problem with the filament or the hot end.

  3. Check your hot end temperature: If the filament isn't melting properly, it could be a problem with the hot end temperature. Check to see if the temperature is set correctly for the filament you're using.

  4. Check for clogs: If the filament isn't extruding properly, there could be a clog in the hot end. Try cleaning the hot end by heating it up and using a needle or cleaning filament to clear out any b...

WARNING: This response is AI generated and may contain errors.