#SV06 update issues

1 messages · Page 1 of 1 (latest)

pale ledgeBOT
#
AI Help

When updating firmware, there are some common issues that people face like power failure, data transmission interruption, corrupt firmware, or a problem with the firmware itself. Here are some potential solutions:

  1. Check your connections: Ensure that your printer is connected properly to your computer via USB, and any additional cables are in place as instructed.

  2. Try different versions of firmware: If you're having issues with the current firmware version, try using an older or newer version. Remember to check for compatibility with your printer.

  3. Change your USB port: Try changing the USB port that the printer is connected to on your computer.

  4. Try another computer: Sometimes the issue can be with the computer rather than the printer, so try using another computer for the firmware update.

  5. Reset your printer: Try performing a power cycle for the printer by turning it off and on again.

If none of these fixes work, you may need to contact the manufacturer for assista...

WARNING: This response is AI generated and may contain errors.
raw ocean
#

I’m doing everything the website says, as well as checking multiple forums but nothings working

#

Just blue brick

hollow glade
#

Maybe you could try reformatting the sd card to have a different allocation unit size, 4096 bits/bytes (I can't remember from the top of my head xD) for flashing firmware to my Ender 3 after 32 kb didn't work and made the printer get stuck in the boot screen

pale ledgeBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

raw ocean
#

Thank you