#Sovol sv06 plus inconsistent leveling

1 messages · Page 1 of 1 (latest)

deft zenith
#

My sovol sv06 plus wack working fine, but then one day I clicked initialize eeprom, and the bed leveling from now on is wack, I leveled the x gantry. The issue in more detail is that I see the z axis moving so it has a mesh, but the right side is much too high and the left is much too low

glass gulchBOT
#
AI Help

Initializing the EEPROM resets all the parameters to default, and this may cause issues like the one you are experiencing. To solve the problem, you can perform the following troubleshooting steps:

  1. Calibrate the bed manually: To do this, you need to move the nozzle to each corner of the bed and adjust the Z-axis height manually until the distance between the nozzle and the bed is correct. You can use a piece of paper to check the distance.

  2. Level the bed with an automatic bed leveling sensor: If your printer has an automatic bed leveling sensor, you can use it to level the bed automatically. You need to adjust the sensor's position and settings until it can detect the bed surface accurately.

  3. Restore the previous EEPROM settings: If you have a backup of the previous EEPROM settings, you can restore them to the printer. To do this, go to the printer's configuration menu and select the option to restore the EEPROM.

If none of these solutions work, you may need to re-flash t...

WARNING: This response is AI generated and may contain errors.
glass gulchBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

deft zenith
#

Deactivate

#

Reactivate*