#ender 5 blue LCD screen

1 messages · Page 1 of 1 (latest)

carmine garnet
#

Yesterday I changed the extruder motor current in my Firmware and uploaded it to my printer, but the LCD is completely blue and will not accept the new firmware. I have uploaded new firmware multiple times to this printer and it has always worked, so I know it's correctly configured for my motherboard, mods, LCD, etc... I opened up the printer and all of the connections look good, so I'm kind of confused why this is happening. Anyone know a solution? I am using Marlin 2.0 on my ender 5 with the v4.2.7 motherboard.

undone jayBOT
#
AI Help

It sounds like you may have corrupted the LCD on your Ender 5. One solution you could try is to perform a factory reset on your printer by following these steps:

  1. Turn off your printer
  2. Press and hold the small rotary knob on the LCD
  3. Turn on the printer while holding the knob
  4. Release the knob once the Ender 5 logo appears on the screen.

If this does not fix the issue, you may need to replace the LCD screen. You could also try re-flashing the firmware without the LCD panel connected to see if that resolves the issue. If none of these solutions work, you may need to contact the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.
carmine garnet
#

this is the screen after inserting the SD card with the firmware and then turning the printer on

IMG_5810.jpg
#

usually after about 10 seconds it would accept the firmware and boot up with the creality logo

#

I also tried another SD card incase this one broke but the same thing happened