#BLTouch failed to raise probe (MainsailOS, Kingroon KP5L)

1 messages · Page 1 of 1 (latest)

lean copper
#

Hey guys, recently I've switched to Klipper from marlin, and I've been having lots of issues with my 3D Touch Sensor (clone of BLTouch), it worked fine on marlin, but now on klipper, every time I try to home I get the "BLTouch failed to raise probe" error, and when I run the QUERY_PROBE command, it always returns TRIGGERED, how can I fix this? The 3d touch moves up and down when i run the commands for that successfully.

left valveBOT
#
AI Help

It sounds like a configuration issue in Klipper. Make sure that your pin mappings and pin names match your printer's configuration. Also, check that your probe offset settings are correct as this can cause the probe to miss the bed.

Additionally, you can try adjusting the BLTouch sensitivity settings to make it less sensitive, as this can sometimes help with probe errors. You can adjust the sensitivity by modifying the "bltouch_sensitivity" value in your Klipper configuration file.

If none of these solutions work, you can try reaching out to the Klipper community for additional support. They may have further insights on troubleshooting the BLTouch probe under Klipper firmware.

WARNING: This response is AI generated and may contain errors.
lean copper
#

Is it possible I have the wrong sensor pin in printer.cfg?

mighty palm
#

change wiring pins

#

afaik default in klipper is using the designated pins and marlin is z stop

#

or use z stop pins in ur config

lean copper
#

i swapped the z endstop with the bltouch cable

#

and it works now

#

magically

#

thanks for the help

#

?solved