ended 5s1 not finishing prints completely

[rare dragon]

Hello everyone I’d like to see if I could get help with my issue I’m currently trying different prints on my ended s1 with sonic pad and iv had success with about 50 percent of them iv printed great ps5 mounts and try re printing same file again and it starts nice but towards end of print it’ll just stop like it finished and not finish out my print. I did a brand new pikachu print last night and I’m missing half its head if I could have some help with the issue I’d really appreciate it thanks have a great day

[scenic yacht]

AI Help

Hi there! Based on the information you provided, it sounds like you may be experiencing an issue with your printer losing connection to the print file, causing it to stop mid-print. Here are a few troubleshooting steps you can try:

1. Check your print file for errors: Sometimes, a print file can contain errors that cause the printer to stop mid-print. Try using a different slicing software to create your print file, or verify that the file is error-free by running it through a free online tool like the MakePrintable file analyzer.

2. Check your USB connection: If you are printing from a computer via USB, make sure that the cable is securely connected and not experiencing any interference.

3. Check your power supply: If your printer is losing power mid-print, it could be due to an issue with the power supply. Try swapping out the power supply with a new one to see if that resolves the problem.

4. Check your settings: Make sure your printer settings are configured correctly, inclu...

WARNING: This response is AI generated and may contain errors.

[tropic hatch]

Is it possible something is resetting the printer?

Like a power bump or otherwise?

AI is right, this is likely a connection issue between the printer and the Sonic Pad or a general power issue causing it to reset.

[rare dragon]

Huh 🤔 do you think my sonic pad is defective

I have it on a reliable source I don’t see why it would fail