#Ender 3 V2 issues

1 messages · Page 1 of 1 (latest)

tender torrent
#

I have an ender 3 v2. And for the last few weeks, i haven't been able to get it to finish hardly any prints. Every time i try, it clogs, or doesn't adhere to the bed, or peels and bunches up. I can barely get it past making a base layer most of the time. I've tried changing the print bed, I've changed and cleaned the nozzle and print head. I've tried applying adhesive to the bed. I've repeatedly re-leveled the bed. I've tried adjusting the printer and print bed temps. Nothing seems to work to make it print properly. Should i just give up on it and wait for a new printer? These are all my failures from just the last few days alone

20230424_174117.jpg rn_image_picker_lib_temp_3e0146dd-b82c-4a42-899e-dc1c4a73f91d.jpg rn_image_picker_lib_temp_e364b2b2-cdb2-4754-b7f3-dfba5608d62a.jpg rn_image_picker_lib_temp_63f56d9c-1348-4893-aa1c-43a96db1c84e.jpg
cinder orchidBOT
#
AI Help

It sounds like you've done a lot of troubleshooting already, so great job on that. Here are a few other suggestions you could try:

  1. Make sure your filament is properly loaded and not tangled or twisted.
  2. Check the filament diameter and make sure it matches what is set in your slicer software.
  3. Clean the extruder gear to make sure it is gripping the filament properly.
  4. Try printing a temperature tower to find the best temperature for your filament.
  5. Consider upgrading to a higher quality nozzle or other printer components.

If none of these suggestions work, it may be time to consider getting a new printer. If you do decide to purchase a new printer, make sure to research and read reviews before making a decision. Good luck!

WARNING: This response is AI generated and may contain errors.