#How can i fix stringing??

1 messages · Page 1 of 1 (latest)

fierce kettle
#

How can i fix stringing??

I have ender 2 pro, i had retraction enabled and i was printing with 200C, later i printed with 195C and i got same result

IMG_20230422_000401.png
young doveBOT
#
AI Help

Stringing occurs when the filament oozes out of the nozzle during printing. There are a few things you can try to fix the issue:

  1. Increase your retraction distance: Increase the retraction distance by 1mm increments up to 6mm or 7mm. This will help to prevent oozing and stringing.

  2. Adjust the retraction speed: You may also want to try increasing the retraction speed to stop the extruder from dragging the filament out of the nozzle.

  3. Temperature control: Sometimes, a change in temperature can help to reduce stringing. Try to adjust the temperature by 5°C up or down from the current temperature to see if it resolves the issue.

  4. Check your filament quality: Poor-quality filament can sometimes cause stringing issues. Switch to a better-quality filament if you suspect that the current filament is the issue.

  5. Enable z-hop: You can also try enabling "z-hop" in your print settings. This will lift the nozzle slightly during travel moves, which can help to reduce stringing.

Gi...

WARNING: This response is AI generated and may contain errors.
fierce kettle
#

should i sent photo?

languid escarp
#

195c is cold for pla

#

try 210+

fierce kettle
#

ok i will try

#

some guy told me to print this

#

idk if it tells anything

#

oh i think that i should set retraction dist to 8 and retraction speed doesnt matter here

#

should i set retraction dist to 8 and speed to 140 mm/s ??

#

can it have any problems?

fierce kettle
#

90 mm/s was better, i will need to try with different settingz

fierce kettle
#

?solved