Infill help.

[low valve]

Hello, I have a model which a layer starts to build apon a layer on infill, I just want to know of this would work, or if it would fail at this point. The layer is printing on infill which isnt fully below it.

[strange current]

AI Help

Printing a layer on top of infill that isn't fully below it may work, but it is not the ideal way to print. It can lead to poor quality prints, as the layer may not adhere well to the infill, resulting in a weak print. It can also cause the print to fail if the infill cannot support the layer that is being printed on it. For best results, it is recommended to ensure that the infill is fully below the layer being printed on it. You can either increase the infill density, or adjust the slicing settings to ensure that the infill is fully supported.

WARNING: This response is AI generated and may contain errors.

[warped spire]

thats pretty normal, there will always be a few layers above, the first one or two are a bit sketch

at some point it has to bridge over the infill and close it up

[low valve]

okay thanks, will it be fine? or would it not work?

[warped spire]

im literally talking about this same problem with someone in #✅｜help-quick-questions rn

[low valve]

okay ill have a look thanks! :)

[low valve]

Thank you!!

?solved