Fokoos Odin 5-F3 Error 7 | 3D Printing | Page 1

sharp hawk · 2023-04-19T20:48:29.692Z

My print was going well up until it stopped and now it's displaying 'Err 7". Both my filament and bed temperature are at 0. Is there a way to clear the error without restarting the print?

AI Help

"Err 7" on 3D printers usually indicates a temperature error. This error occurs when the printer's firmware detects a fault in the temperature sensor, thermistor, or heater cartridge.

Firstly, you should try to clear the error by checking all your connections and power supply. Ensure that the temperature probe is properly connected and that there is no damage to the wiring or insulation.

Another common cause of this error is a disconnected thermistor or hotend. In this case, you may need to disconnect and then reconnect the hotend and thermistor wires.

If none of these solutions work, you may need to restart the print, as a firmware crash could be the reason for the error. Ensure that the firmware is up to date and that you have the appropriate software installed.

#Fokoos Odin 5-F3 Error 7