#3d printer is not open

1 messages · Page 1 of 1 (latest)

muted panther
#

while printer was open,i needed to turn off and turn on again.I turned off and when i turned on,it didint turn on

high robinBOT
#
AI Help

If your 3D printer is not turning on after you have turned it off and on, here are a few things you can try:

  1. Check the power source: Ensure that the printer is plugged into an outlet that is working correctly. Try plugging something else into the same outlet to confirm it is working.

  2. Check the power cables: Check that the cables are plugged in correctly at both ends, i.e., the printer and the power source. If the cables are loose, plug them in correctly and try turning on the printer again.

  3. Check the fuse: If the printer has a fuse, check if it needs to be replaced.

  4. Check the power supply: Verify that the power supply is not damaged. If it is, have it serviced or replaced.

If none of these solutions work, you may need to seek technical support from the manufacturer of your 3D printer.

WARNING: This response is AI generated and may contain errors.
warm portal
#

what do you mean the printer was open

#

also the AI gives good advice here

muted panther
#

sorry for bad english

#

AI s 4th advice is check the supply but how i do that

warm portal
#

what is your printer?

muted panther
#

its very bad printer.i wish i hadnt bought

warm portal
#

turn on the printer switch and then try and move the x gantry back and forth does that do anything

muted panther
#

i ll try

muted panther
warm portal
#

turn on the screen

muted panther
#

no it didnt

warm portal
#

do you have a multimeter

muted panther
#

Unfortunately no

warm portal
#

it will be difficult to tell then what is the problem

#

try replace the fuse in your power cord, if it has one

#

or try another power cord

muted panther
#

okay

muted panther
#

do you mean power cable?

warm portal
#

yes power cable

#

fuse is this

muted panther
#

i am using 230V

warm portal
#

that doesnt matter

muted panther
#

wait a min i will send a pic

muted panther
warm portal
#

i cant tell whats happening in that photo its too dark

#

also take a picture of where the power cord goes into the printer

muted panther
muted panther
warm portal
#

the fuse goes in the slot with the metal clips

#

a new fuse

#

old one might be broke

muted panther
#

i have a new fuse

warm portal
#

if that doesnt work try a new cable

muted panther
#

okay

warm portal
#

if that doesnt work youll need a multimeter to find out what is happening

#

it might also be that the display is unplugged from the mainboard

muted panther
#

it didnt work

warm portal
#

did you see if the display is correctly plugged in

muted panther
#

no i ll check

warm portal
#

if it is plugged in correctly i can't help you, you will need a multimeter

muted panther