Extrusion issue

[keen viper]

Mainsail+Klipper
Prusa Slicer
Ender 3

Please I need some help

Wierd gaps:
No over/under extrution
No wet filament
Recommended temperature
They are not seams

[astral sage]

AI Help

Thank you for reaching out for help. Based on your description, it sounds like you are experiencing gaps in your 3D prints. Here are a few common causes of gaps in 3D prints and the potential solutions:

1. Inconsistent extrusion: Ensure that your extruder is calibrated and that the filament is loaded and feeding properly. Check that you are using the recommended extruder and print temperatures for your filament.

2. Too little infill: Increase the infill percentage to ensure that the interior of the print is filled in properly.

3. Z-hop issues: If your printer is retracting too much between layers, the print head can create a void when it comes back down. Try increasing the minimum layer time or disabling Z-hop to avoid this issue.

4. Small gaps can also occur due to a slight misalignment in the print bed or slicer settings that aren't optimized for the specific model or filament used. You can try realigning the print bed and checking the slicer settings, especially the nozzle si...

WARNING: This response is AI generated and may contain errors.

[astral sage]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[exotic inlet]

could we have a look at your full model