#FLSun SR Leveling issue

1 messages · Page 1 of 1 (latest)

unborn knoll
#

So basically I just got a new heatblock bro e3d and I installed the nozzle and leveled it but when I try to print it scrapes the buildplate and I cannot print, I tried auto leveling but heatblock too big and autolevel not fit because of that

viral brookBOT
#
AI Help

It sounds like you need to adjust your Z-axis offset. This is the distance between the nozzle and the bed.

To adjust the Z-axis offset, you can try the following steps:

  1. Move the nozzle to the center of the bed.
  2. Lower the nozzle until a sheet of paper can barely fit between it and the bed.
  3. Using your printer's LCD screen or host software, adjust the Z-axis offset until the nozzle is just barely touching the paper.
  4. Save the new Z-axis offset setting and test a print.

If the nozzle is still scraping the bed, you may need to adjust the offset further until it is just right.

WARNING: This response is AI generated and may contain errors.
viral brookBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

flat ice
#

yea do check your z offset and tune it if need be as the AI says