#Steppers no longer work after firmware update - Ender 3

1 messages · Page 1 of 1 (latest)

slim surge
#

After installing new firmware on my ender 3 none of the steppers move, they are enabled but i cannot move them through firmware and homing doesnt work either since the steppers dont move, have anyone had this issue?

orchid atlasBOT
#
AI Help

It's possible that the firmware update may have caused an issue with your printer's settings. Here are a few troubleshooting steps you can try:

  1. Double-check that you installed the correct firmware for your Ender 3 model. Firmware intended for a different printer model may cause issues.

  2. Check that all of the connections to your stepper motors are secure and correctly wired. Loose wires may prevent the stepper motors from functioning properly.

  3. Confirm that the motor current settings are properly set in your printer's firmware. If the current setting is too low, your motors may not have enough power to move.

  4. Check that your printer's endstops are correctly wired and functioning. If your printer believes that the endstops are engaged, it won't move the stepper motors.

  5. Check the power supply voltage. Low voltage could also mean the stepper motors are unresponsive.

If none of these troubleshooting steps solve the issue, you may need to revert to the previous firmware ...

WARNING: This response is AI generated and may contain errors.
orchid atlasBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

late thunder
#

I had this issue when changing my ender 3 v2 to Marlin 2.1.2. have you tried resetting EEPROM?

#

reset everything to default