took 15 hours to print It is for airsoft made it all by my self
#GHOST MW2
opal citrus
mild nimbus
cool. Can you share print settings?
analog olive
nice
opal citrus
cool. Can you share print settings?
It is scaled to fit my face I can give you the settings but you would need to scale to fit your face
mild nimbus
i am just interested in like material used, print settings etc (-: i wouldnt have a need to make one for myself
opal citrus
Material wad PLA bed temp 60c nozzle temp was 190 infill 40 with a 0.4 nozzle with support took 15 hours and 49 mins rest were default for cura
steady iris
Is that a microphone grille in each eye? lol
raw cypress
took 15 hours to print It is for airsoft made it all by my self
Cool! Just make sure to wear some goggles and mouth protection under it
raw cypress
No I have steel under the nose and that mesh on the eye are also steel
Bbs can shatter on impact and send shards of plastic into your eye through the mesh
opal citrus
My airsoft had banned those bbs that shatter on impact and all Bbs are tested to make sure they are good
I am ordering a thin plastic sheet to ho on the. Eye as well
raw cypress
I just mean in general normal bbs can still send shards of plastic through the mesh
opal citrus
I am ordering a thin plastic sheet to ho on the. Eye as well
I know
raw cypress
Remember you can never take too many precautions with your eyes
You only get one set
opal citrus
I know my risk I know I play for fun I am ordering plastic to go on the eys I am going to bed byeee
raw cypress
Good good, have fun with it! Just make sure to be safe