Spacebar ticks loudly on one side

[dire inlet]

Thanks for posting your support request!

Please note, the support center is only for community-based support with technical troubleshooting and general questions.

For official Wooting Customer Support, please use the Contact Us button on the Wooting Hub or email your request to [e-mail]
note: use the email address associated with your order for fastest resolution

Looking for information about your specific order?
You can find that on the Wooting Hub! There you can also add upgrades, change/confirm your shipping address, and much more.

Is your order about to ship and you need to pause it for any reason?
Place it On Hold via the Wooting Hub!
https://hub.wooting.io

[sharp turtle]

The wire probably isn't balanced properly or maybe it's just cuz the stock stabs are bad

[marble flame]

Make sure you but the grease (not lube) on the wire, and do it only on the ends of the wires and at the angle. Then use the lube on the stem housing on the sides, and in the stem itself. IT shoud eliminate any sort of ratles.

[keen trench]

i spent all of yesterday balancing and relubing each part of the stabilizer from the wire to the housing, nothing gets rid of the loud sound. it happens the most noticeably towards the center of the space bar and on the left side

[marble flame]

Can you record the sound?

[sharp turtle]

Still sounds like wire balance issues if it's lubed properly

You can always get new stabs

Tx stabs are good

[keen trench]

this is from before i did anything to it, and it still does this after reapplying lube a few times

[marble flame]

Hmm you sure its not a switch?

Did you try a spare one just to check, also if you tap the stab stems\and or move them up down they move smoothly?

It looks\sounds to me like something is sticking a bit

[keen trench]

yeah i switched it for a spare one, does it on that one too

i can record another one

most noticeable towards the center

[marble flame]

is this the plate stabilizers or screw on (do you have module version or the prebuilds\two?)

I presume its the plate stabs

[keen trench]

plate mounted, this is the two HE

[marble flame]

you need to check where the rattle actually comes from, if you tap the stabs only do you hear it?

maybe you'll need to try replace the stab

you can check some of the aftermarket ones like TX AP stabilizers

[keen trench]

probably, scared of voiding warranty though, and money is kinda tight

[marble flame]

I don't think that would void the warranty, and stabs should be very cheap

[keen trench]

you got a link for tx ap's? i do have money on my amazon account right now if they're available there

[marble flame]

huh I don't think its on the amazon

https://www.maxgaming.com/en/pc-accessories/keyboard-accessories/custom-keyboard/stabilizers

but you can check here, find one compatible to your plate

[keen trench]

https://a.co/d/9qWLUY1 How about these?

[marble flame]

yeah I heard Durock are good

you just need to make sure the sizes fit your plate for the TWO