Been having issue in game with the W key

[pulsar cedar]

Anyone else have a wooting60he and everytime you press the W key in game your character will move for a brief moment then stop and you will have to retap the w key for your character to stop? Been having this issue and idk what’s causing it. All I did was swap the board and added the silicon instead of flab on top of the pcb and used the lighter 45g Keller switches and everything I’ve done was with Wooting own in house parts. I tried switching the switches to different Keller 45g switches I had left over I had around 10 left over I tried them and still having the issue. I’m also on the newest update for the 60he too. Idk if other switches are having this same issue but so far it only is the W key that is experiencing this issue.

[full solar]

Thanks for posting your support request!

Please note, the support center is only for community-based support with technical troubleshooting and general questions.

For official Wooting Customer Support, please use the Contact Us button on the Wooting Hub or email your request to [e-mail]
note: use the email address associated with your order for fastest resolution

Looking for information about your specific order?
You can find that on the Wooting Hub! There you can also add upgrades, change/confirm your shipping address, and much more.

Is your order about to ship and you need to pause it for any reason?
Place it On Hold via the Wooting Hub!
https://hub.wooting.io

[pulsar cedar]

I think it may be from when I tried to do the double rubber o rigs that came with the board I used 2 of them one under the pcb where the pcb makes contact with the screws on the alumaze60 and one in between the pcb and could be causing the light from the switch to not register the W key sometime cuz it’s not being pushed down too much but don’t know for sure

It was the burger mount I believe it was called I may have done it incorrectly but I was using the rubber o rings that came with the board for it it was called a mini burger mount

[hybrid basin]

i'm trying to understand where you put the o-rings? can you send me a screenshot of your performance tab inside wootility?

[pulsar cedar]

Yes I can

This is the performance tab for wootility

[pulsar cedar]

the rubber o rings that came with the wooting board I put under where the stabalizers are to make the stabilizers less wobbly when pressing on them suppose to make them sound better

I put it in the little hole where the screws would screw into in the stablizers

Here's this as well

[hybrid basin]

try making the rapid trigger higher, try 0.2 or 0.3

i had some issues when i used 0.15mm on my own board

[pulsar cedar]

Ok I’ll try that I also turned off square joystick and snappy joystick at same time idk if it’s placebo or anything but it feels a little more sponsivr and faster having only one option on at once