#Mitru Belt Contraptions

1 messages · Page 1 of 1 (latest)

drowsy escarp
#

what's the reason to limit rate like that in the first place?

vivid hinge
#

sushi

#

3/5 rate limiter leaves enough space for a 2/5 rate limiter to fill all the gaps perfectly, and vice versa
which means if one resource runs out, it won't fill the belt and leave no room for the other resource(s)

drowsy escarp
#

how about circuit based limiter? top one is 3/5, bottom one is 2/5
working by disabling belt for 2/5 or 3/5 of the time

vivid hinge
#

you come into my belt contraptions thread and peddle combinators?

#

also pretty sure you only need 3 combinators total

teal aurora
#

When using the rate limiters for sushi, you still need some protection to stop the belt from backing up right?

vivid hinge
vivid hinge
#

or wait. it's already 4 wide

#

i am dumb

austere idol
vivid hinge
#

what happens when one runs out

austere idol
#

Needs protection against it, but that's a simple wire

vivid hinge
#

we don't talk about wires in this household

austere idol
#

top belts read, bottom belt uses this condition

vivid hinge
#

banned

#

splitter sushi zone

teal aurora
#

Unpowered rate limiters are still cool though.

austere idol
#

It's because this is for looped sushi belts. No protection against backing up would allow e.g. copper to fill the entire loop when there's no iron input. Once iron is back, all the copper on the belt needs to go somewhere.

teal aurora
#

I guess it would drain too slowly in some/most situations, depending on whether the loop-back is specific to that rate-limiter, or if it can go to other sinks as well.

austere idol
#

It wouldn't drain at all if there's no Iron on the belt because it's taken up by Copper.