software-support
Hi all,
I want to stop my ECC from spamming outside my network
Filament Loading Race Condition
Input Shaper . Real or fake ?
Open centauri
Unable to connect without a restart
Too much filament purging.
nozzle wipe before temp drop to 180c before bed level
Printer seems to forget level, plus other small bugs i have noticed while using the OC firmware
centauri_carbon_developer_mode - in linux
Investigation into M600 filament change ramming into the cutter arm
No camera feed from CC
Screen stuck on Open Centauri splash screen after reboot
Can't Install Firmware.
Can't access remote control
Rollback from OC to official software
Light keeps turning on and off after installing open centauri
Printing in the air after a print finishes and I start a new one
5G/WPA3 Network Issues
Printer takes 5 minutes to boot when blocked from internet
Not updating
webui not showing camera
Do you think that the flash keys will eventually be released?
Why did Elegoo switch slicer software from Cura to an Orca-clone with the CC?
turn light on during a print
BTT SFS 2.0
Random under extrusion on prints
How do I disable the ECC from constantly pinging outside my network?
How to keep the heatbed on?
printer.cfg or user_printer.cfg question
Jailbreaking firmware in order to customize firmware
Camera connection error disabling lights
CentauriSideCar Installation
test123