It loads fine... or seems to. It just has major issues with respooling. It respools about 10 percent.... then rest is just a hot mess.....
#LDO Build BoxTurtle not respooling enough
atomic oxide
torn karmaBOT
<@&1304550334839918672>
Please run this debugging script when not printing and post the resulting link in chat.
atomic oxide
I think I may have figured it out.... I think..... they are rubbing on the sides... causing issues.
proven fog
the spooler wheels? yeah that'll do it
atomic oxide
Yeah....
Sigh....
Any alternatives that are better than those screw hubs?.
I think I'm going to just get the ldo injections ones
proven fog
sometime you can get away with just grabbing them and twisting against the other, they should have a noticable detent
atomic oxide
Yeah.... I just can't get them good....
I think my trays are also a little too narrow
native ravine
Yeah.... I just can't get them good....
Sometimes you can try to grab the center with some pliers or jam a screwdriver in tactfully to try to get some more leverage on the end you want to keep stationary
atomic oxide
I t hink its the trays more than the wheels
rigid marsh
Make sure theyre seated all the way onto the shaft as well and its not drifted a bit to either side causing the rub
proven fog
IDK where you are but the injection molded trays are for sure worth the purchase
proven fog
another BT clearly lol jk
proven fog
nope
atomic oxide
Alright.... this poroject on hold for a bit.... annoying I'm going to have to totally disassemble
atomic oxide
Ordered.... now I just need to wait for them to show up.
I may also try using these... https://www.printables.com/model/1334343-boxturtle-hex-wheel-drive
I really wish the shaft had a flat side....
proven fog
I mean you could file small flats into it
atomic oxide
Fair....
I may try those other ones first. Guessing that it may be because I printed them in asa.... But.... Either way. Waiting for the new trays before I deal with any of it
proven fog
well ping us again if you need more help once you get those