[Solved] Spool Assist

[cursive fern]

Looking at spool assist but I guess i'm needing to find out what I need to change / update for my config files. Can someone direct me to a good config file with spool assist. Thank you

[old axle]

<@&1304550334839918672>

[brisk parcel]

What command were you trying to run?

[cursive fern]

@brisk parcel I just left my computer but it is the enable spool assist lane 1 command. Looking through my config files im missing the lane assist config that were listed in the AT documentation but if I add it I get an error.

[brisk parcel]

It all has defaults and should be enabled by default.

[brisk parcel]

If you use SET_WEIGHT LANE=lane1 WEIGHT=850 though and set them to something close or under what you think the material is left it should enable

[cursive fern]

that worked...at least it accepted the command. I was trying ENABLE_ESPOOLER_ASSIST LANE=lane1 and was getting unknown. This came straight from the documentation

[brisk parcel]

@honest cairn is that command outdated?

[cursive fern]

I'm not sure. it is in the documentation under lane movement. It is a macro that I apparently don't have or not set-up.

[honest cairn]

No that's the right command

[honest cairn]

What is your AFC version that prints out in your console?

[cursive fern]

V1.0.11-2-g83fb073b this one and i see there is updated one

[honest cairn]

Oh you need to update to get the espooler code

[brisk parcel]

#afc-updates message

[cursive fern]

Ok Thank you and just wondering but is there any place that has any photos and anything of how people are running the bowden. I'm putting in a by-pass and just wondering how everyone else is routing everything.

[honest cairn]

Maybe ask in #boxturtle or #afc-squad

[cursive fern]

Thank you

[cursive fern]

looks like just clicking update will not work for this one. I have to install through the Raspberry?

Maybe added modules that I don't have (extras, extras/AFC_assist.py)

That did the trick. That command is recognized now.

[Solved] Spool Assist