Hello! Could someone tell me what the problem could be? After changing the plastic, there are small leaks in small areas... it seems that the flow rate here is very high, but without BT, the plastic profile is set up perfectly.
#After changing small leaks
brittle dawn
what slicer?
topaz quarry
what slicer?
Orca,I made all the settings changes according to the instructions.
brittle dawn
i would first retry the print with a small prime tower to catch any ooze / boogers.
if it still continues - providing the gcode as well as a video of a tool change in process during the load and beginning of printing may provide further clues
topaz quarry
i would first retry the print with a small prime tower to catch any ooze / booge...
Ok, I'll try a purge tower, I think it should be fine with the tower. After the nozzle cleaning, some filament still manages to ooze out before the print resumes. I think it's around 1-2mm of filament hanging from the nozzle. It's hard to capture this on camera.
brittle dawn
did you change 'Retraction while switching material' under printer settings / Extruder 1?
shoudl be set to 0
but yeah there may always be a bit of ooze, that's why a small prime tower is very cheap insurance to ensure cleaner prints.
topaz quarry
Yes, I set all the slicer settings according to the manual. But maybe I missed it — is there a variable in afc settings that controls retraction after the nozzle cleaning?