HI, do you know if i can use the RJ11 from the Octopus Pro 1.0 to connect the can bus to the Turtle Board from the LDO kit ?
i additionally am already using can bus on this board but through the U2C from Bigtreetech.
Many thanks, Cristian
#Octopus Pro 1.0 RJ11 - CAN BUS
broken arrow
chilly scrollBOT
<@&1304550334839918672>
vague apex
You can but then it’s a different CAN network and you need to configure it as such
That’s the beauty of CAN though, you can connect multiple devices to the U2C without issue
broken arrow
Ahhh ok I see so I can just take two additional wires that goes to the ams turtle right ? I mean connecting them to the same outputs on the U2C ?
vague apex
Correct
broken arrow
Ahhh ok I see so I can just take two additional wires that goes to the ams turtl...
U2C outputs : I mean the can pins on this board