Filament loaded in bypass, not doing tool load

[rancid fox]

I have the same issue, did you figure this out yet?

[pulsar geode]

is you virtual bypass switch turned on in your filament sensor section?

[rancid fox]

Forgive me for not being more fluent with this, but where might I find that setting at? I scrolled through and didn’t see that setting. Thanks in advance for your help.

[pulsar geode]

You use mainsail or fluidd

[rancid fox]

So first off, thanks for the help! I had the switch in the hub not triggering and the switch for my bypass was not plugged into the correct port. All good now.