Hello, I have an issue where If i want to change filament before print start, it always cools down to 25 degrees which can take too much time.
I would like to find where to change this parameter as I did not find these 25 degs anywhere in config.
https://termbin.com/jxa7 this is my config.
#[SOLVED] BT - first filament manual change waits for 25 degrees (when printer is restarted)
crystal forum
I have found out one thing - when unloading a line with material set it takes the data from config (210 for PLA and 255 for ASA - I changed this from 235). But if the material is not set the default value is 25 degs. Would be much better for the default value to be 210-220 degs as this would work for most of the materials.
pine vapor
your minimum extrude temp is set to 20 in your extruder config
as of today the default is minimum extrude temp + 5C
if you set the material type it will use the default_material_temp for that material in AFC.cfg
there is a change coming in dev which will allow the default material type to be set
crystal forum
your minimum extrude temp is set to 20 in your extruder config
Thanks! Will ramp it up.