I have two issues that I am troubleshooting. The first one is that the lanes will not respool when ejecting. They move forward to pull the fillament in fine, but they do not run in reverse to respool. The second issue I am having is that the LEDS are not coming on. I checked all connections to the board and the plug is in the right spot.
#Respoolers Will Not Rewind when Ejecting and LED's are not working
subtle ferry
subtle ferry
Yes it is
Two secs let me grab it
Is this true? "Also I left out an important detail, it only
enables the motors on eject if your dist_hub is greater than 200, if your hub is in your BT they will not enable. I would be more worried if they didn't enable when retracting from your toolhead"
bright cliff
that may be old information, ubt it's possible
do regular tool hcanges and rewinnds work
and have you seen the spooler youtube video?
@strong isle tracking in here too
strong isle
Is this true? "Also I left out an important detail, it only
enables the motors ...
Better way to test this would be to use the TEST macro to see if they sping backwards. Try to run TEST LANE=lane1 and the n20s on lane1 should move https://github.com/ArmoredTurtle/AFC-Klipper-Add-On/blob/main/docs/command_reference.md#test
subtle ferry
Ok let me go load one and try
No response from any lane
Hang on I might have it
It got knocked out of Buck when I was tearing respoolers
strong isle
ahhh, that will do it
subtle ferry
Yup. If a respooler doesn't respond at full speed but sort of does at low. I'm assuming there is a problem with it?
It sort of ticks and then clicks no perceived change in speed
strong isle
is it possible to get a video
subtle ferry
Yes let me eat and I'll send it over
subtle ferry