Been calibrating the BT and I am a bit confused. I did the automatic configuration and got the Hub lengths for each lane. I then ran the command for calculating the Bowden tube for each lane and they differ quite significantly. Which value do I use?
Lane 1: 1630 ------- (Hub 150)
Land 2: 1645 ------- (Hub 85)
Lane 3: 1655 ------- (Hub 90)
Lane4: 1755 ------- (Hub 155)
Thanx
#Bowden tube length [solved]
hasty river
quasi falcon
Been calibrating the BT and I am a bit confused. I did the automatic configurati...
I'm sure someone else will jump in, but I typically just run the bowden calibration for a single lange. In this case, I'd probably set it to 1630, and then observe how many short moves it takes to get to the toolhead sensor (assuming you are using one) and then adjust the length from there.
hasty river
I'm sure someone else will jump in, but I typically just run the bowden calibrat...
I've set it to 1640 and it seems to be working well - no short moves, thanks