build-help
tuning process? Getting started guide?
Tuning
K1 newbie flash help
Other
[SOLVED]Problem : purge tower z offset
Other
[SOLVED] Problem to see AFC-Lite in CAN Bus
Build Issue
AFC-Lite No status lights, have 1 Led lit on Boxturtle, no longer see it listed in serial by id
Build Issue
Other
[SOLVED] Working on the spooler - Motor Question LDO-12FN20-GB30-06500-10D
Build Issue
(SOLVED)Feeds good then doesn't then parks
Tuning
Other
Non moving z after macro
Tuning
Build Issue
Other
(Solved)Leg2 will not accept filament
Other
[SOLVED] Configuration for 2 x AFC boards on a 6 lane
Build Issue
[Solved] Flashing AFC Lite
Build Issue
Other
[SOLVED] Issues with Toolhead unload
Tuning
Other
[SOLVED] Katapult can setup.
Other
[SOLVED] Layer height shift
Tuning
[SOLVED] Tried my hand at printing two different colors on separate objects and it went badly...
Other
Problem with loading through TNPro
Other
Problems with unload
Tuning
[SOLVED] When configured to new printer... BT Tool Unload moves past all four extruder gears grip.
Other
Disaster BT
Build Issue
[Solved] Hub loading issues on lane 3 and 4
Tuning
[SOLVED]Tried to swap working BT to another printer... klipper stuck on startup. Help?
Other
[SOLVED] Getting ready for first MMU print... Help with a sanity check?
Tuning
Other
SOLVED Toolhead sensor AFC_hardware.cfg throwing an error.
Build Issue
Purge/Kick help
Tuning
[Solved - thanks everyone] Pre-flight checklist?
Tuning
Build Issue
quarter full spool - ejected forward
Tuning
(Solved)Full spools getting loose
Tuning
[solved]start and end gcode
Tuning
[Solved] AFC-Lite not entering DFU mode
Build Issue
AFC Klipper Addon installation
Build Issue
[Solved] Filament stuck in extruder
Tuning
Other
Lost Communication with MCU
Other
[Solved] Cut Direction
Other
String prevention + purge block + filament doesn't reach toolhead sensor (just barely!)
Tuning
PI won't see TN2 board
Other
[Solved] Can not update MCU 'mcu' config as it is shutdown
Tuning
[SOLVED] Sometimes extrusion stoppage
Tuning
Unloading during Calibration
Tuning
[SOLVED] BT spaghetti machine
Tuning
Build Issue
[SOLVED] CAN vs USB afc-lite help
Build Issue
Sanity check my wiring, please
Other
(Solved)Snappy cutter config help
Other
(Solved)No RGBs
Build Issue
LED Lane 3 not working [SOLVED]
Other
Help slicing/printing multicolor trays
Other
disaster1234
Build Issue
Too much retraction
Tuning
What is this on these trays?
Build Issue
Motors alternative
Other
Configuration Help
Tuning