I have had trouble getting both symmetry and a good angle when i am decorating items, so I believe they should add some sort of way where you can apply decorations at a fixed angle and/or at a fixed point
Example: this could allow me to put a pin decoration at a 90 degree angle at the tip of an arrow and have the tip of the pin be centered to the tip of the arrow itself.
#Spoilers for lab: make a snap grid for decorations or just some sort of feature that is similar
1 messages · Page 1 of 1 (latest)
#📝・lab-feedback-and-suggestions
Syau
you dont have to put it there gng
It’s called lab suggestion for a reason, so you’re supposed to put it there
again you don't need to you need to spoiler it here though
Then why did they make a lab suggestion channel if everyone was gonna put it here
cause at first you could only put them there. plus here non lab rats can help
Wym?
Non lab rats can help?
add on to the suggestion
Yea, but non lab rats don’t know as much as lab rats, you just have YouTube videos to watch to see lab
so? its still useful
- W idea..
- It’ll prob be too hard to make, since they would have to add new meshes that are slightly bigger for each item.
wha no it wont?
its a grid it can be done by math
very simple math may I add
how i would want this to work it you can choose the angle 0-45
I would say that the angles would be from 0-180 degrees on each axis, as for the positioning it would be on a grid where every point is one tenth of a 1x1x1 pillow. Both of these would be on a grid with the positioning being determined my coordinates on the grid and the rotation just being a numerical value that you can edit, ( the rotations rotate clockwise ).
you lost me at "math"
It would be on a numbered grid but it’s not like your doing algebra
you lost me at "numbered"
you lost me at "you"
you lost me
you lost
"lost" you at me
at
t
