New to orca but I think I have my settings down but after I print my benchy I notice some fails any help to fix would be amazing
#LK5 Pro
loud tree
karmic lintel
can you post your orca 3mf file of the benchy
west zinc
New to orca but I think I have my settings down but after I print my benchy I no...
You seem to have under extrusion. For the bottom layer that could just be first layer height being too close / far but really considering there are more issues than just those I would recalibrated from the beginning
Also use a orcaslicer calculator to prevent potential errors
loud tree
i noticed if i change the overhang speeds there is a differance but need to calibrate those settings
loud tree
im going to try to restart the calibration all over, does anybody have any suggested profiles i can use for sunlu pla + to start with?
karmic lintel
Basic pla should be fine