clever mantle
Can someone help me please? No matter what i do, i can not remove the slowed down area from my prints. I have tried layer times, do not slow down for walls, etc. I put all changes back and uploaded here if some one can help. thanks.
*****************Solution ***************
It was the "extrusion rate smoothing". Setting this to zero and making no other changes fixed it.
Thanks to @winged island for his patience and time.
winged island
there is still something wrong, can you create a file and just add a cube from with in orca
clever mantle
ALright. Added a cube to another file. Cube speed looks excellent, but other file dosen't. Only thing i see is that cube is solid and spacer has inner walls.
clever mantle
how did you create the pla1.3mf modle?
I cut it in the slicer becuase i was making test prints. anytime i print anythiing, one of the walls always slows to a crawl.
Why the difference in speed?
winged island
you had slowed it down in the cooling section of the filament profile
clever mantle
I don't understand. Which setting?
winged island
clever mantle
even if i change both to 0, it still slows down to 75 with a flow rate less than 2. can you tell me the speeds you get when you slice it please?
worn depot
even if i change both to 0, it still slows down to 75 with a flow rate less than...
Set it to 1000 , and 1.
If you are talking about these speed changes, that's because you are using scarf seams.
winged island
you are asking a different question now?
clever mantle
Thank you very much for taking the time to go through this with me. Scarf seams was exactly what it was. I appreciate it greatly.
worn depot
Thank you very much for taking the time to go through this with me. Scarf seams ...
Actually, it's the extrusion rate smoothing setting.
Turning scarf seams off partially fixes it, but you can actually leave those on and turn off the extrusion rate smoothing which will fix both that and this odd speed difference happening elsewhere:
clever mantle
Can't stop walls from slowing down in slice! Fixed-"extrusion rate smoothing"
clever mantle
Turning scarf seams off partially fixes it, but you can actually leave those on ...
That was it. Setting extrusion rate smoothing to 0 and changing nothing else fixed it.... even keeping scarf seams on like you said. Thank you very much.
