Huge issue with tree supports | OrcaSlicer | Page 2

hardy star Feb 22, 2026, 5:36 AM

#

or maybe the firmware

#

printer is definitely running differently

#

it sounds different

brisk lion Feb 22, 2026, 5:37 AM

#

could have been a little bit of everything 🙂

hardy star Feb 22, 2026, 5:37 AM

#

i didnt set the line widths right though shit

#

but no more banding

brisk lion Feb 22, 2026, 5:38 AM

#

glad its fixed , now you can print what you started doing 😁

hardy star Feb 22, 2026, 5:38 AM

#

gonna check the wall thickness again, setting the width to .4

#

whats a good thickness to actually run at for quality vs functional parts?

brisk lion Feb 22, 2026, 5:40 AM

#

line with 0.42 and measure what it is '

hardy star Feb 22, 2026, 5:49 AM

#

oh, i ran .4 and it gave me mostly .4, theres a few spots where its like .38 or .42

hardy star Feb 22, 2026, 6:00 AM

#

brisk lion line with 0.42 and measure what it is '

.41 to .43

brisk lion Feb 22, 2026, 6:06 AM

#

that seems all good

hardy star Feb 22, 2026, 6:59 AM

#

brisk lion that seems all good

so you think .42 width is a good starting point for printing figures at?

#

just got linear advance set up too

hardy star Feb 22, 2026, 9:01 AM

#

Printed that bust we said was going to be difficult to print. It printed relatively well and the supports came off, albeit with a pair of cutters and some effort. Changed a few settings and printing a bigger model. 12 hr eta but I think we are good

#

1016 messages later and it seems like the main culprit was my bed temp fluctuating. Thanks for the help guys

hardy star Feb 23, 2026, 2:22 AM

#

support material is still basically impossible to remove from more delicate areas without a stupid amount of force

#

i just broke the head off this model trying to get the supports off

#

12 hr print.

#Huge issue with tree supports