Y-axis shift after manual filament swap | OrcaSlicer | Page 1

wise chasm Dec 20, 2025, 4:19 PM

#

Running Ender 3v3 KE and suddenly started getting a Y axis shift upon restarting print after swapping filaments.

I tried tightening my Y-axis belt, slicing different models and it keeps happening.

Anyone else have suggestions?

astral marsh Dec 20, 2025, 7:27 PM

#

Slow down the acceleration in Y

gaunt mantle Dec 20, 2025, 11:06 PM

#

likely loosing steps during that fast travel move

wise chasm Dec 21, 2025, 2:18 PM

#

How could I remedy that?

astral marsh Dec 21, 2025, 6:34 PM

#

Slow down the acceleration speed in orca

astral marsh Dec 22, 2025, 8:37 AM

#

@wise chasm slow down these also make sure your jerk setting are around the value of 3

crystal swift Dec 22, 2025, 9:54 AM

#

Those speeds tho 👀

sweet edge Dec 22, 2025, 2:13 PM

#

That's just accel, not actual speed. 10K is pretty common on modern printers.

crystal swift Dec 22, 2025, 2:15 PM

#

Well yeah thats correct (modern) my ender 5 ain't doing that haha

#Y-axis shift after manual filament swap