Hello, i try to print petg with my p1p printer. i tried multiple settings now, different bed types etc. i cant get it working any ideas? already dried the filament for 12h
#SOLVED: Overture PETG Transparent Layer Problems
compact temple
wicked gazelle
have you cleaned the bed? if so how did you clean it?
can you print the correct test file for your nozzel size from here
#1363262234767261777 message
compact temple
have you cleaned the bed? if so how did you clean it?
yes ofc
with water
i tried 2 different bed types
wicked gazelle
water may not be good enough, use warm soapy water , and then wipe down with isopropanol
your other print of the flow rate tiles looks like it might be underextruding, how fast are you printing , layer height and nozzel diameter?
compact temple
water may not be good enough, use warm soapy water , and then wipe down with is...
but its not like the print isnt sticking on the build plate..
wicked gazelle
your first print looked like it wasnt sticking in the middle.
compact temple
0.4 nozzle
compact temple
your first print looked like it wasnt sticking in the middle.
that was the 2nd layer x(
and layer hight is/was 0.2
wicked gazelle
temperture of the nozzel?
compact temple
wicked gazelle
230
no where near hot enough , bump to 250 , and try our test file
and reduce fan spped
compact temple
kk
wicked gazelle
i would stsrt with the default settings
compact temple
i would stsrt with the default settings
looking better so far
smoky elbow
These speeds are MUCH too fast for regular PETG, especially at the temp you are using.
It explains perfectly why your first layer is good and the rest are not.
wicked gazelle
These speeds are MUCH too fast for regular PETG, especially at the temp you are ...
i got them to bump tempurature to 250
260 may be better
compact temple
It explains perfectly why your first layer is good and the rest are not.
i can try after the test
ty
smoky elbow
I use 240-245 for PETG, but I also use a print speed of 100 or less, and fan at 40% or less.
compact temple
@smoky elbow @wicked gazelle thank you very much, its working now with lower speed