normal maple
I would like to add a height modifier to my model, which I’ve already managed to do successfully. However, my goal now is to apply the modifier only to the area marked in red.
Is that even possible? When I try to split the model into two parts, I can’t apply the height modifier to just one area – the software always selects the entire model.
dry osprey
I would like to add a height modifier to my model, which I’ve already managed to...
You would probably have to do this with a modifier object instead.
normal maple
and how this works?
normal maple
You would probably have to do this with a modifier object instead.
when i generate a modifiercube i cant adjust the layer high in this area
dry osprey
when i generate a modifiercube i cant adjust the layer high in this area
Correct. Instead you have to positon the modifier object where you want the changes to be.
normal maple
Correct. Instead you have to positon the modifier object where you want the chan...
and where now i can adjust the layerhight?
dry osprey
dry osprey
and where now i can adjust the layerhight?
Oh, that's what you are after? Would have been helpful to state that from the beginning. It's not possible. That can only be adjusted for the whole plate at the same time unless you use the By object print sequence.
normal maple
Oh, that's what you are after? Would have been helpful to state that from the be...
yes. well ur right. my bad
normal maple
Oh, that's what you are after? Would have been helpful to state that from the be...
seperating the part in 2 seperate parts doesnt help right?
dry osprey
seperating the part in 2 seperate parts doesnt help right?
No, not unless you are going to print them using the By Object print sequence as I said.
normal maple
a now i understand
