winged rune
I have been using orca 2.3.0-dev in lan only mode for a few days without any issue.
Today orca won't connect to my printer 😦
Any idea on how to fix it?
What i have done so far trying to fix it:
Any help is greatly appreciated!
winged rune
Uninstalled and reinstalled orca slicer but that did not help
What did fix it was uninstalling and reinstalling bambu studio.....
Not sure what happened but I would imagine something related to the network plugin
@wanton plover
Sorry for the ping. Not sure if you know what might have happened here but i thought I'll ping you just in case (It's my understanding you are handling the better bambu lan support, and for which i am very grateful 
)
wanton plover
Could it be that the ip address changed?
Make sure to set your printer to have static ip.
winged rune
Could it be that the ip address changed?
no, that was already set to static. And it was 100% not a firewall issue (i did try disabling it and that did not fix it)
Is there any log file you could use if this happens again in the future?
proper owl
I've had issues when I was running both Bambu Studio and Orca Slicer at the same time. BS could connect to the printer and Orca didn't. When I only run Orca it will (usually) connect no problems. Sometimes I have to manually wake the printer up and wait. Sometimes I have to restart Orca and wait.