I'm dumb. What settings do I need to change to enforce 200mms on Bambu P1 printers?

[coarse monolith]

changing speed settings is too obvious I guess, so what's the problem?

[flint lagoon]

Better question. How do I force a consistent speed through no matter how many objects on the plate?

Keeping in mind that Layer Time doesn't matter the more parts are on the plate

[coarse monolith]

set all speed values to the same and remove any restriction like volumetric, layer time and slowering on curves etc

this will normalize the print speed, kindly

[flint lagoon]

I was looking for 'slow on curves' but I couldn't find that under the speed settings. I think it might be important for the inner detail of most of my parts that are like this

[coarse monolith]

additionnal objects should follow the current preset

[flint lagoon]

this being the main problem

[flint lagoon]

Is this hidden in the filament settings?

[coarse monolith]

no it's in the cooling tab

you can also force a minimum print speed threshold that might rule to all

[flint lagoon]

Then a different problem pops up. Slow Down for Overhangs always leaves one layer at a different speed

[coarse monolith]

the idea is to disable it, don't pay attention to my own settings

[flint lagoon]

So Slow Down for Curled Perimeters doesn't have anything to do with Slow Down for Overhangs, but it's being shown/hidden when that featured is on or off?

[coarse monolith]

it is related to overhangs actually

the best example is the front of the benchy boat, it's not a strait overhang but curved