im confused how to connect the slicer and printer via wifi
i have an ender 3 v3 ke
#new to fdm printing and orca slicer
still ice
nvm got it, is there an order I should try printing off these calibration tests or should i just go top down
median loom
First make sure you added the Ender 3 v3 to supported printers.under prepare (left top) is the printer section. make sure the ender 3 v 3 box is tagged.. choose the wifi icon after your printer, choose 0cto/klipper in host type and enter the ip-adress of your Ender. then save machine as. now if you choose Ender as printer, if you click on device it will give access to the printer.
still ice
First make sure you added the Ender 3 v3 to supported printers.under prepare (le...
what does host type do? i changed it to the creality one :o
should i change back
gleaming frigate
nvm got it, is there an order I should try printing off these calibration tests ...
e-steps, temp, max flow, flow ratio, PA, retraction.
median loom
oh, shit, i forgot ender 3 still runs on creality os
your right to choose creality for type
still ice
was running the temp test and it popped off about half way through the print
