#Anycubic Kobra 3 Combo

1 messages · Page 1 of 1 (latest)

harsh totem
#

I guess it's too early to ask if someone would have a profile for Orca Slicer yet, but just in case.. I got the printer now and I believe Orca is going to do a better job with reducing the waste.

Thanks!

warm granite
#

I know some YouTubers who did a preview of the printer were given some OrcaSlicer profiles, so hopefully they are publically available sometime soon.

harsh totem
prisma verge
#

@warm granite @tight fiber I am one of those youtubers with the printer and the profile. @tight fiber particlarlly, here it is. This 3MF has the settings baked in. It's been great, though until Orca adds multicolor support I'm still using the Anycubic slicer forthat.

📎 rope_bowl-Contains_Orca_parameters.3mf.zip
#

This is their official Orca profile. THey may change it, of course, but it's printing solidly.

harsh totem
#

Perfect, thanks. I have tried to copy settings from their Orca fork to the actual Orca, but haven't really tried it. The fork works fine, but it does not have a connection to printer yet so the other Anycubic slicer is better in sending the data directly to the printer.

prisma verge
#

Yeah. FWIW their slicer on the thumb drive isn't awful. I mean it's not good but it gets the job done, you can do multi filmanet colors in it, and even paint. Paint tools seem pulled right from bambu/orca. It makes a very clean STL

#

The slicer on their site doesn't support the kobra 3 yet. it's their 1.3 not 1.4

warm granite
#

Thanks David, discord hid this chat from me so only just saw it, really appreciate the profile and good to know it could be possible to use Orcaslicer for everything.

prisma verge
#

@warm granite could you give this profile a test and see if it's making unusually long print times? I just laid out a few gridfinity things and it's estimating 12 hours, vs. the 55 minutes estimated in their slicer.

warm granite
#

Sure I will re-run the current print once it is done ( has about 7 hours left )

warm granite
#

I put up a model with single colour and the time was roughly the same, however I put up one with 3 colours and it is much higher on the anyslicer, I believe it is because it does not count the colour changing time.

#

Also do you know if its possible to connect the printer directly for network prining with that profile for orcaslicer? or not just yet.

prisma verge
#

New profile and instructions from Anycubic, they say they're more optimized.

📎 Kobra3.zip
warm granite
#

Thanks again David, it is very appreciated.

prisma verge
#

I wonder if they're going to release whatever is needed for orca to know it's a multifilament system.

warm granite
#

Hope so, that and LAN mode would be huge.

prisma verge
#

Yup. Their own slicer doesn't suck for multidevice management, but you can't take a GCODE file from orca and upload it via their slicer, which is a bummer. Though their slicer seems to have the new icons of orca.

warm granite
#

New firmware update, prints seem the same, option for auto leveling on print seems to now be there.

open wave
harsh totem
autumn sequoia
tulip fulcrum
#

Hello, does current Orca Slicer support network print for Kobra 3?

harsh totem
tulip fulcrum
harsh totem
tulip fulcrum