forest bramble
Hello friends, I am now at the end of my knowledge. Again and again when I read the various. materials, I end up with the same mistakes as in the attached photo. My K1 has no hardware upgrades, only a washer on the extruder because it had the problem with slipping during extrusion.
What else can I change?
zenith plume
Hello friends, I am now at the end of my knowledge. Again and again when I read ...
If you havent done so, try tuning your esteps/mm and flow rate. Also look at small area flow compensation tuning by Teaching tech. Could possibly help those lines be a little nicer looking or atleast consistent.