Hello!! Any Kobra 2 plus config por orcaslicer? I can't import from prusa slicer, and i want to try this awesome
Slicer!
#ANYCUBIC Kobra 2 PLUS
cunning salmon
cunning salmon
Thank you so much! But when i put in the orcaslicer doesnt work
0 profiles imported or something like that
gentle phoenix
i can import these 3 files without problems
gentle phoenix
Go and Look for another discord Server that Supports English or your language that is for 3d printing. The Support in this Anycubic Discord ist Not very good. Where did you come from?
cunning salmon
i'm from Spain, but now my printer is working well with your profile, i will make some test, but i was very hyped about this slicer, Thank you so much!
gentle phoenix
No Problem
obtuse condor
Cheers for this too. Just got to work out how to import them into the software
left pendant
Wow this is great thank you
i have the same question about to import. but i think it is under: File -> Import -> Import Configurations. Then import the JSON File
Danke schön für die tolle Arbeit Bravo
left pendant
No Problem
Ich danke dir wirklich für den code. Wie hasst du das gemacht?
left pendant
No Problem
die frage ist immer noch das importieren denn es kommt folgende nachricht: Es sind 0 Konfigurationen importiert. (Nur nicht-systemische und kompatible Konfigurationen)
Tipp: Stellen Sie sicher, dass Sie den entsprechenden Drucker hinzugefügt haben, bevor Sie die
Konfigurationen importieren.
The question is still importing, because the following message comes: There are 0 configurations imported. (Non-system and compatible configurations only)
Tip: Make sure you have added the appropriate printer before you die
Import configurations.