#GPT-4 Conversation #1100841874840883282

1 messages · Page 1 of 1 (latest)

cosmic basinBOT
small fox
#

**write a code for esp32 to display joke's on lcd

#

hi

cosmic basinBOT
# small fox hi

Hello! How can I help you today? If you have any questions or need assistance, feel free to ask.

small fox
#

write a code for esp32 to display joke's on lcd

cosmic basinBOT
# small fox write a code for esp32 to display joke's on lcd

I can provide you with a simple example of code for an ESP32 to display jokes on an LCD screen. This example uses an I2C LCD and the Arduino IDE for programming. Before starting, make sure to install "LiquidCrystal_I2C" library on your Arduino IDE. Here's the code:

#include <Wire.h>
#include <LiquidCrystal_I2C.h>

// Adjust the following based on your LCD's I2C address and dimensions (columns, rows)
LiquidCrystal_I2C lcd(0x27, 16, 2);

// Replace these jokes with your preferred ones
const char* jokes[] = {
  "Why did the chicken cross the road? To get to the other side!",
  "Why was six afraid of seven? Because seven eight nine.",
  "Why don't scientists trust atoms? Because they make up everything!"
};

const int numJokes = sizeof(jokes) / sizeof(jokes[0]);

void setup() {
  // Initialize the LCD
  lcd.init();
  lcd.backlight();
  lcd.clear();

  // Initialize serial communication
  Serial.begin(115200);
}

void loop() {
  for (int i = 0; i < numJokes; i++) {
    lcd.clear();
    displayJoke(jokes[i]);
    delay(5000); // Delay for 5 seconds between jokes
  }
}

void displayJoke(const char* joke) {
  int jokeLength = strlen(joke);
  int startPosition = 0;

  while (startPosition < jokeLength) {
    lcd.clear();
    for (int i = 0; i < 2; i++) {
      for (int j = 0; j < 16; j++) {
        if ((startPosition + j) < jokeLength) {
          lcd.setCursor(j, i);
          lcd.print(joke[startPosition + j]);
        }
      }
      startPosition += 16;
    }
    delay(2000); // Delay for 2 seconds before scrolling
  }
}

This code will display a sequence of jokes on a 16x2 I2C LCD screen. You can customize the jokes by updating the 'jokes' array. Change the I2C address, columns, and rows according to your specific LCD module.

Please make sure to connect your ESP32 to the LCD according to your I2C pins (SDA, SCL) and power supply (VCC, GND).

small fox
#

Bitcoin price today

cosmic basinBOT
small fox
#

hi